Safran CORTEX Series - 6 SATELLITES CONFIGURATION EXAMPLES; 6.1 Reminder: procedure for configuring the CORTEX HDR from an MCS file

HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Page 369
6 SATELLITES CONFIGURATION EXAMPLES
Next table is a non-exhaustive list of in-orbit satellites with their main downlink configuration
parameters: modulation, bit rate, PCM code, Viterbi mode, output mode.
These parameters can be entered manually on the CORTEX HDR or, more easily, by loading the MCS
file indicated in the left column. These MCS files can be found in:
C:\Program Files\IN-SNEC\CrtxMcs\Default\Config
Reminder: procedure for configuring the CORTEX HDR from an MCS file:
1. Click on FILE, CLOSE. If necessary, save the current configuration to the active MCS
document.
2. Click on FILE, OPEN. Select a new MCS document in the list and click on OK to load it. The
configuration status turns to (unless the new MCS document is strictly identical to
the previous one).
3. Enable the configuration mode if necessary (click on in the lower toolbar and enter the
Configuration password).
4. Reconfigure the unit by clicking on . The configuration status turns to .
WARNING:
SATELLITE INFORMATION LISTED IN THIS SECTION IS NOT CONTRACTUAL.
THE OPERATOR SHOULD KNOW THE DETAILED FEATURES OF THE TRACKED SATELLITE
AND PROGRAM THE CORTEX HDR ACCORDINGLY.