Safran CORTEX Series - Control

HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Page 308
Control 4.5.7.1.1
Parameters in this window are described in DRG.
 Channels configuration:
DISK AND MEMORY
ALLOCATION %
FOR EACH MOUNTED
DPU
Disk and PC RAM buffer partitioning. For TCP-IP and FTP recording modes,
allows to allocate a percentage of the available memory for each mounted TM:
0% to 100 %
LOGICAL CHANNEL
FOR EACH MOUNTED
DPU
For FTP mode only, allows for the current pass to select a logical channel (first
level FTP directory) 0 to 255.
ACTIVE PARTITION
FOR EACH MOUNTED
DPU
For FTP mode only, allows for the current pass to select the active partition 0 to
64.
ACTIVE DISK
CONTROLLER
FOR EACH MOUNTED
DPU
For FTP mode only, allows for the current pass to select the active disk
controller 0 or1. In case of one available controller, the value must be set to 0.
DISK LATE %
Status of the delay during the recording of the data on the disk.
DISK OVERRUN
Overrun during the recording of the received data (disk).
MEMORY LATE %
Status of the delay during the writing of the received data in the buffer memory.
MEMORY OVERRUN
Overrun during the writing of the received data (buffer memory).
 Disk Management:
MODE
In TCP-IP mode only. Select FIFO Mode (permanent recording. The
storage area is structured as a FIFO) or Manual Erase (record data until the
storage area is full, then stop and wait for manual erase of the recorded
session).
Note: it is recommended to use the FIFO mode (with auto-erase) only for
single recording session (auto-erase of the least recent TM Files).
LEVEL PERCENTAGE
Warning
In FTP mode only. If different from 0, allows to
define a storage level threshold above which a
warning is reported. Value expressed in percentage:
1% to 80%
Alarm
In FTP mode only. If different from 0, allows to
define a storage level threshold above which an alarm
is reported. Value expressed in percentage: 1% to
80%.
In case of alarm, the oldest files are deleted until to
obtain a level equivalent to the warning storage level