HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
CORTEX HDR GUI 4.5
Conventions &Warnings 4.5.1
IN THE FOLLOWING SECTIONS, EACH CONFIGURATION PARAMETER, STATUS OR ALARM
IS RED-MARKED WITH THE NAME OF A CORTEX « UNIT ». THIS MARK ALLOWS TO LOCATE THE PARAMETER, STATUS
OR ALARM IN THE ETHERNET INTERFACE CONTROL DOCUMENT IN ANNEX 1.
The following marks are used:
(SWID) : Refer to the Software & ICD Version ID table
(GLOB) : Refer to the Global CORTEX table
(DMU) : Refer to the Demodulator Unit table
(DPU) : Refer to the Data Processing Unit table
(DCU) : Refer to Diversity Combining Unit table
(MGLO) : Refer to the Modulator Global table
(DGU) : Refer to the Data Generating Unit table
(MDU) : Refer to the Modulating Unit table
(IFO) : Refer to the IF Output table
(CHM) : Refer to the Channel Modeling table
(MFI) : Refer to the Modulator Format Input table
(MFO) : Refer to the Modulator Format Output table
(DRG) : Refer to the Data Recording Global table
(DRU) : Refer to the Data Recording Unit table
(PLBK) : Refer to the Playback Unit table
(PROJ) : Refer to the Project-specific table
PROGRAMMING PARAMETERS DEFINED AS FLOAT VALUES IN THE INTERFACE CONTROL DOCUMENT
CAN BE ENTERED IN FLOAT OR REAL FORMAT (SEE ANNEX 1).
PARAMETERS DEFINED AS INTEGER VALUES MUST BE ENTERED IN REAL FORMAT.
PARAMETERS MARKED « HEX » IN THE GRAPHICAL USER INTERFACE MUST BE ENTERED
IN HEXADECIMAL FORMAT. OTHER PARAMETERS MUST BE ENTERED IN DECIMAL FORMAT.
To Next Page
Loading...
