Safran CORTEX Series - Page 317

HIGH DATA RATE RECEIVER
HDR-4G+ USER’S MANUAL
Ref. DTU 100782
Is.Rev 3.5
Date: June 1, 2021
© Safran Data Systems – IMP000074 e14r1
This document is the property of Safran Data Systems.
It cannot be duplicated or distributed without expressed written consent.
Page 317
SORT B
Enable or disable the Sort B operation
Offset: Offset in bits in the frame of the position of the word to extract to be
used for the sorting B operation (0 is the first bit of the synchronization marker)
Size: Size in bits of the word to extract, from 0 to 8
File: Index of the Sort B configuration file, from 0 to 255
SORT C
Enable or disable the Sort C operation
Offset: Offset in bits in the frame of the position of the word to extract to be
used for the sorting C operation (0 is the first bit of the synchronization marker)
Size: Size in bits of the word to extract, from 0 to 8
File: Index of the Sort C configuration file, from 0 to 255
EXTRACT A
Enable or disable the operation of Extract A, the operation is the same as for
Sort A,B and C operations except that it impacts only the files names and not
the directories.
Offset: Offset in bits in the frame of the position of the word to extract to be
used for the Extract A operation (0 is the first bit of the synchronization marker)
Size: Size in bits of the word to extract, from 0 to 8
File: Index of the Extract A configuration file, from 0 to 255
Note: the data values used in the filtering, sorting and extract operations are defined in their
corresponding configuration files selected by the index values.
 Filename:
The basic name of a recorded file is the date of its creation (default name). From this basic
name a number of programmable markers can be added:
R/W
Enable or disable the insertion of the R/W marker in the recorded files
names
CHANNEL
Enable or disable the insertion of the selected Logical Channel marker in
the recorded files names (The selection of the logical channel for a recording
session is done in the “Global Disk and Memory Management Window)
EXTRACT A
Enable or disable the insertion of the Extract A marker in the recorded files
names
FILE NBR
Enable or disable the insertion of the File Number marker in the recorded
files names (counter of the number of generated files during a recording
session inside a dedicated directory)
FILTER RS
Enable or disable the insertion of the RS Filter marker in the recorded files
names
FILTER A
Enable or disable the insertion of the Filter A marker in the recorded files
names
SORT A OR VIRTUAL
CHANNEL
Enable or disable the insertion of the Sort A marker (Generic mode) or the
Virtual Channels marker (CCSDS mode) in the recorded files names