Machining the workpiece
4.10 Editing a program
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
139
See also
Editor settings (Page 147)
Correcting a program (Page 123)
Opening and closing the program (Page 641)
Generating a G code program (Page 204)
4.10.1 Searching in programs
You can use the search function to quickly arrive at points where you would like to make
changes, e.g. in very large programs.
Various search options are available that enable selective searching.
Search options
● Whole words
Activate this option and enter a search term if you want to search for texts/terms that are
present as words in precisely this form.
If, for example, you enter the search term "Finishing tool", only single "Finishing tool"
terms are displayed.
● Exact expression
Activate this option if you want to search for place holders in program lines (e.g. "*" or "?")
that you want to replace.
Note
Search with place holders
When searching for specific program locations, you have the option of using place holders:
• "*": Replaces any character string
• "?": Replaces any character
Requirement
The desired program is opened in the editor.
To Next Page
Loading...
Need help?
General
