Alarm, error and system messages
13.3 Displaying messages
Turning
688 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
13.3 Displaying messages
PLC and part program messages may be issued during machining.
These message will not interrupt the program execution. Messages provide information with
regard to a certain behavior of the cycles and with regard to the progress of machining and
are usually kept beyond a machining step or until the end of the cycle.
Overview of messages
You can display all issued messages.
The message overview contains the following information:
● Date
● Message number
is only displayed for PLC messages
● Message text
Procedure
1. Select the "Diagnostics" operating area.
2. Press the "Messages" softkey.
The "Messages" window appears.
To Next Page
Loading...
