Introduction
1.4 User interface
Turning
56 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
1.4.13 Protection levels
The input and modification of data in the control system is protected by passwords at
sensitive places.
Access protection via protection levels
The input or modification of data for the following functions depends on the protection level
setting:
● Tool offsets
● Zero offsets
● Setting data
● Program creation / program editing
Note
Configuring access levels for softkeys
You have the option of providing softkeys with protection levels or completely hiding
them.
References
For additional information, please refer to the following documentation:
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Softkeys
Machine operating area Protection level
End user
(protection level 3)
Parameters operating area Protection level
Tool management lists
Keyswitch 3
(protection level 4)
To Next Page
Loading...
