Siemens SINUMERIK 828D Turning - Tool Dimensioning

Tool management
11.4 Tool dimensioning
Turning
584 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
11.4 Tool dimensioning
This section provides an overview of the dimensioning of tools.
Tool types
&XWWLQJWLSDQJOH
5HIHUHQFHGLUHFWLRQ
+ROGHUDQJOH
&XWWLQJWLSOHQJWK
/HQJWK=
/HQJWK;
&XWWLQJHGJHUDGLXV
Figure 11-7 Finishing tool (Type 510)
/HQJWK=
/HQJWK;
&XWWLQJWLSZLGWK
&XWWLQJWLSOHQJWK
5DGLXV
Figure 11-8 Plunge cutter (Type 520)