Programming technology functions (cycles)
8.7 Additional cycles and functions in ShopTurn
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
507
Parameters Description Unit
Z3 Target position of special axis (abs or inc)
Note:
Incremental dimension: The sign is also evaluated.
mm
AWZ Target angle (abs) or target angle referred to the actual position (inc) Degrees
GS Target angle (abs) or target angle referred to the actual position (inc) Degrees
F Machining feedrate
Alternatively, rapid traverse
mm/rev
mm/min
mm/tooth
Input defining which side of the contour the cutter travels in the traversing
direction:
Radius compensation to right of contour
Radius compensation to left of contour
Radius compensation off
Radius compensation
The previously programmed setting for radius compensation is used.
8.7.12 Programming a circle with known center point
To program a circle or arc with a known center point, use the "Circle center point" function.
The tool traverses a circular path from its actual position to the programmed target position
at the machining feedrate. The system calculates the radius of the circle/arc on the basis of
the entered interpolation parameter settings I and K.
Procedure
1. The ShopTurn program to be processed has been created and you are
in the editor.
2. Press the menu forward key and the "Straight Circle" softkey.
3. Press the "Circle center point" softkey.
To Next Page
Loading...
Need help?
General
