Siemens SINUMERIK 828D Turning - Page 508

Programming technology functions (cycles)
8.7 Additional cycles and functions in ShopTurn
Turning
508 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameters Description Unit
Direction of rotation Direction of rotation in which the tool travels from the circle starting point to the
circle end point:
Direction of rotation clockwise (right)
Direction of rotation counterclockwise (left)
Y
Z
J
K
Machining plane, peripheral surface C
Target position Y (abs) or target position X referred to the last programmed
position (inc)
Target position Z (abs) or target position Y referred to the last programmed
position (inc)
Circle center point J (ink).
Circle center point K (inc).
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
mm
mm
Y
Z
J
K
Machining plane, peripheral surface Y
Target position Y (abs) or target position X referred to the last programmed
position (inc)
Target position Z (abs) or target position Y referred to the last programmed
position (inc)
Circle center point J (ink).
Circle center point K (inc)
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
mm
mm
X
Y
I
J
Machining plane face C
Target position X ∅ (abs) or target position X referred to the last programmed
position (inc)
Target position Y (abs) or target position Y referred to the last programmed
position (inc)
Circle center point I (ink)
Circle center point J (inc)
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
mm
mm
X
Y
I
J
Machining plane face Y
Target position X (abs) or target position X referred to the last programmed
position (inc)
Target position Y (abs) or target position Y referred to the last programmed
position (inc)
Circle center point I (inc).
Circle center point J (inc).
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
mm
mm