Machining the workpiece
4.7 Starting machining at a specific point
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
125
Procedure
1. Press the <REPOS> key.
;
=
2. Select the axes to be traversed one after the other.
3. Press the <+> or <-> key for the relevant direction.
The axes are moved to the interrupt position.
4.7 Starting machining at a specific point
4.7.1 Use block search
If you would only like to perform a certain section of a program on the machine, then you
need not start the program from the beginning. You can also start the program from a
specified program block.
Applications
● Stopping or interrupting program execution
● Specify a target position, e.g. during remachining
To Next Page
Loading...
