Programming technology functions (cycles)
8.1 Drilling
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
313
8.1.13 Displaying and hiding positions
Function
You can hide any positions in the following position patterns:
● Position pattern line
● Position pattern grid
● Position pattern frame
● Full circle position pattern
● Pitch circle position pattern
The hidden positions are skipped when machining.
Display
The programmed positions of the position pattern are shown as follows in the programming
graphic:
x Position is activated = displayed (position is shown as a cross)
o Position deactivated = hidden (position shown as a circle)
Selecting positions
You have the option of either displaying or hiding positions - by activating the checkbox in
the displayed position table either using the keyboard or mouse.
Procedure:
1. The part program or ShopTurn program to be processed has been
created and you are in the editor.
2. Press the "Drilling" and "Positions" softkeys.
3. Press the "Line/Grid/Frame" or "Full/Pitch Circle" softkeys.
To Next Page
Loading...
