EasyManuals Logo

Siemens SINUMERIK 828D Turning User Manual

Siemens SINUMERIK 828D Turning
822 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #470 background imageLoading...
Page #470 background image
Programming technology functions (cycles)
8.5 Contour milling
Turning
470 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
8.5.13 Contour spigot residual material (CYCLE63, option)
Function
When you have milled a contour spigot and residual material remains, then this is
automatically detected. You can use a suitable tool to remove this residual material without
having to machine the whole spigot again, i.e. avoiding unnecessary non-productive motion.
Material that remains as part of the finishing allowance is not residual material.
The residual material is calculated on the basis of the milling cutter used for clearing.
If you mill several spigots and want to avoid unnecessary tool changeover, clear all the
spigots first and then remove the residual material. In this case, for removing the residual
material, you also have to enter a value for the reference tool TR parameter, which, for the
ShopTurn program, additionally appears when you press the "All parameters" softkey. When
programming, proceed as follows:
1. Contour blank 1
2. Contour spigot 1
3. Clear spigot 1
4. Contour blank 2
5. Contour spigot 2
6. Clear spigot 2
7. Contour blank 1
8. Contour spigot 1
9. Removing residual stock spigot 1
10. Contour blank 2
11. Contour spigot 2
12. Removing residual stock spigot 2
Software option
For removing residual stock, you require the option "residual stock detection
and machining".
Clamping the spindle
For ShopTurn, the "Clamp spindle" function can be set up by the machine manufacturer.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
See also
Clamping the spindle (Page 231)

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D Turning and is the answer not in the manual?

Siemens SINUMERIK 828D Turning Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 828D Turning
CategoryController
LanguageEnglish

Related product manuals