Simulating machining
5.9 Editing and adapting a simulation graphic
Turning
194 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
...
...
2. Press the "Arrow right", "Arrow left", "Arrow up", "Arrow down", "Arrow
clockwise" and "Arrow counterclockwise" softkeys to change the
position of the workpiece.
- OR -
Keep the <Shift> key pressed and then turn the workpiece in the desired
direction using the appropriate cursor keys.
5.9.4 Modifying the viewport
If you would like to move, enlarge or decrease the size of the segment of the graphical
display, e.g. to view details or display the complete workpiece, use the magnifying glass.
Using the magnifying glass, you can define your own segment and then increase or
decrease its size.
Precondition
The simulation or the simultaneous recording is started.
Procedure
1. Press the "Details" softkey.
2. Press the "Magnifying glass" softkey.
A magnifying glass in the shape of a rectangular frame appears.
3. Press the "Magnify +" or <+> softkey to enlarge the frame.
- OR -
Press the "Magnify -" or <-> softkey to reduce the frame.
- OR -
To Next Page
Loading...
Need help?
General
