Siemens SINUMERIK 828D Turning - Changing the View; Enlarging or Reducing the Graphical Representation

Machining the workpiece
4.13 Mold making view
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
169
Procedure
1. Press the "Search" softkey.
A new vertical softkey bar appears.
See also
Searching in programs (Page 139)
Replacing program text (Page 141)
4.13.5 Changing the view
4.13.5.1 Enlarging or reducing the graphical representation
Precondition
● The mold making view has been started.
● The "Graphic" softkey is active.
Procedure

...

1. Press the <+> and <-> keys if you wish to enlarge or reduce the graphic
display.
The graphic display enlarged or reduced from the center.
- OR -
Press the "Details" and "Zoom +" softkeys if you wish to increase the
size of the segment.
- OR -
Press the "Details" and "Zoom -" softkeys if you wish to decrease the
size of the segment.
- OR -