Machining the workpiece
4.10 Editing a program
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
143
Press the "Cut" softkey to delete the selected program blocks.
Note: When editing a program, you cannot copy or cut more than 1024
lines. While a program that is not on the NC is opened (progress display
less than 100%), you cannot copy or cut more than 10 lines or insert
more than 1024 characters.
Note
The buffer memory contents are retained even after the editor is closed, enabling you to
paste the contents in another program, as well.
Note
Copy/cut current line
To copy and cut the current line where the cursor is positioned, it is not necessary to mark or
select it. You have the option of making the "Cut" softkey only operable for marked program
sections via editor settings.
See also
Opening additional programs (Page 146)
Editor settings (Page 147)
Keys of the operator panel (Page 26)
4.10.4 Renumbering a program
You can modify the block numbering of programs opened in the editor at a later point in time.
Requirement
The program is opened in the editor.
Procedure
1. Press the ">>" softkey.
A new vertical softkey bar appears.
2. Press the "Renumber" softkey.
The "Renumbering" window appears.
To Next Page
Loading...
