Machining the workpiece
4.10 Editing a program
Turning
142 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Note
Replacing texts
• Read-only lines (;*RO*)
If hits are found, the texts are not replaced.
• Contour lines (;*GP*)
If hits are found, the texts are replaced as long as the lines are not read-only.
• Hidden lines (;*HD*)
If hidden lines are displayed in the editor and hits are found, the texts are replaced as
long as the lines are not read-only. Hidden lines that are not displayed, are not replaced.
See also
Editor settings (Page 147)
4.10.3 Copying/pasting/deleting a program block
Requirement
The program is opened in the editor.
Procedure
1. Press the "Mark" softkey.
- OR -
Press the <SELECT> key.
2. Select the desired program blocks with the cursor or mouse.
3. Press the "Copy" softkey in order to copy the selection to the buffer
memory.
4. Place the cursor on the desired insertion point in the program and press
the "Paste" softkey.
The content of the buffer memory is pasted.
- OR -
To Next Page
Loading...
Need help?
General
