EasyManuals Logo

Siemens SINUMERIK 828D Turning User Manual

Siemens SINUMERIK 828D Turning
822 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #430 background imageLoading...
Page #430 background image
Programming technology functions (cycles)
8.4 Milling
Turning
430 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
P
- (selection
option only for
table selection
"without")
Pitch ...
• In MODULUS: For example, generally used for worm gears that mesh with a gear
wheel.
• Per inch: Used with pipe threads, for example.
When entered per inch, enter the integer number in front of the decimal point in the
first parameter field and the figures after the decimal point as a fraction in the
second and third field.
• In mm/rev
• In inch/rev
The tool used depends on the thread pitch.
MODULUS
Turns/"
mm/rev
in/rev
∅ Nominal diameter
Example: Nominal diameter of M12 = 12 mm
mm
H1 Thread depth mm
DXY Maximum plane infeed mm
rev Finishing allowance in X and Y - (only for ∇) mm
αS Starting angle Degrees
8.4.12 Engraving (CYCLE60)
Function
The "Engraving" function is used to engrave a text on a workpiece along a line or arc.
You can enter the text directly in the text field as "fixed text" or assign it via a variable as
"variable text".
Engraving uses a proportional font, i.e., the individual characters are of different widths.
Approach/retraction
1. The tool approaches the starting point at rapid traverse at the height of the retraction
plane and adjusts to the safety clearance.
2. The tool moves to the machining depth FZ at the infeed feedrate Z1 and mills the
characters.
3. The tool retracts to the safety clearance at rapid traverse and moves along a straight line
to the next character.
4. Steps 2 and 3 are repeated until the entire text has been milled.
5. The tool moves to the retraction plane in rapid traverse.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D Turning and is the answer not in the manual?

Siemens SINUMERIK 828D Turning Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 828D Turning
CategoryController
LanguageEnglish

Related product manuals