Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
9
Table of contents
Preface ......................................................................................................................................................
5
1 Introduction..............................................................................................................................................
23
1.1 Product overview .........................................................................................................................
23
1.2 Operator panel fronts ...................................................................................................................
24
1.2.1 Overview ......................................................................................................................................
24
1.2.2 Keys of the operator panel...........................................................................................................
26
1.3 Machine control panels................................................................................................................
35
1.3.1 Overview ......................................................................................................................................
35
1.3.2 Controls on the machine control panel ........................................................................................
35
1.4 User interface...............................................................................................................................
38
1.4.1 Screen layout ...............................................................................................................................
38
1.4.2 Status display...............................................................................................................................
39
1.4.3 Actual value window ....................................................................................................................
42
1.4.4 T,F,S window ...............................................................................................................................
43
1.4.5 Current block display ...................................................................................................................
46
1.4.6 Operation via softkeys and buttons .............................................................................................
46
1.4.7 Entering or selecting parameters.................................................................................................
48
1.4.8 Pocket calculator..........................................................................................................................
50
1.4.9 Context menu...............................................................................................................................
52
1.4.10 Touch operation ...........................................................................................................................
52
1.4.11 Changing the user interface language.........................................................................................
53
1.4.12 Entering Asian characters............................................................................................................
54
1.4.13 Protection levels...........................................................................................................................
56
1.4.14 Online help in SINUMERIK Operate............................................................................................
58
2 Setting up the machine............................................................................................................................
61
2.1 Switching on and switching off.....................................................................................................
61
2.2 Approaching a reference point.....................................................................................................
62
2.2.1 Referencing axes .........................................................................................................................
62
2.2.2 User agreement ...........................................................................................................................
63
2.3 Modes and mode groups .............................................................................................................
65
2.3.1 General ........................................................................................................................................
65
2.3.2 Modes groups and channels........................................................................................................
67
2.3.3 Channel switchover......................................................................................................................
68
2.4 Settings for the machine ..............................................................................................................
69
2.4.1 Switching over the coordinate system (MCS/WCS) ....................................................................
69
2.4.2 Switching the unit of measurement..............................................................................................
70
2.4.3 Setting the zero offset ..................................................................................................................
71
2.5 Measuring the tool .......................................................................................................................
73
2.5.1 Measuring a tool manually...........................................................................................................
73
2.5.2 Measuring a tool with a tool probe...............................................................................................
75
2.5.3 Calibrating the tool probe.............................................................................................................
77
To Next Page
Loading...
