Siemens SINUMERIK 828D Turning - Drilling with Manual Machine

Working with Manual Machine
14.6 More complex machining
Turning
718 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
14.6.1 Drilling with Manual Machine
The same range of technological functions (cycles) is available as in automatic mode for
drilling on the face or peripheral surface of a workpiece:
Machine manufacturer
Please refer to the machine manufacturer's specifications.
⇒ ⇒
⇒
⇒
⇒
Parameters
The parameters of the input screen forms correspond to the parameters under Automatic
(see Section "
Drilling (Page 277)").