Managing programs
12.4 Creating a directory / program / job list / program list
Turning
646 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
4. If necessary, select a template if any are available.
5. Enter the desired workpiece name and press the "OK" softkey.
The name can be a maximum of 24 characters long.
You can use any letters (except accented), digits or the underscore
symbol (_).
The directory type (WPD) is set by default.
A new folder with the workpiece name will be created.
The "New G Code Program" window opens.
6. Press the "OK" softkey again if you want to create the program.
The program will open in the editor.
12.4.3 Creating a new G code program
You can create G code programs and then render G code blocks for them in a
directory/workpiece.
Procedure
1. Select the "Program manager" operating area.
2. Select the desired storage location and position the cursor on the folder
in which you would like to store the program.
3. Press the "New" softkey.
The "New G Code Program" window opens.
4. If necessary, select a template if any are available.
5. Select the file type (MPF or SPF).
If you are in the NC memory and have selected either the
"Subprograms" or "Part programs" folder, you can only create one
subprogram (SPF) or one main program (MPF).
To Next Page
Loading...
