Tool management
11.8 Magazine
Turning
614 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
11.8.3 Unload all tools
You have the option of unloading all tools from the magazine list at the same time.
Requirements
The following requirements must be satisfied so that the "Unload all" softkey is displayed and
available:
● Magazine management is set up
● There is no tool in the buffer / in the spindle
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Procedure
1. The magazine list is opened.
2. Press the "Unload all" softkey.
A prompt is displayed as to whether you really want to unload all tools.
3. Press the "OK" softkey to continue with the unloading of the tools.
The tools are unloaded from the magazine in ascending order
according to the magazine location number.
4. Press the "Cancel" softkey if you wish to cancel the unloading
operation.
To Next Page
Loading...
Need help?
General
