EasyManuals Logo

Siemens SINUMERIK 828D Turning User Manual

Siemens SINUMERIK 828D Turning
822 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #519 background imageLoading...
Page #519 background image
Programming technology functions (cycles)
8.7 Additional cycles and functions in ShopTurn
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
519
Note
Special feature regarding "rear face":
The work offset that you choose in the parameter screen is only activated and not calculated.
This means that the workpiece zero for counterspindle machining should be stored in the
work offset. In addition, parameter ZV is not evaluated.
8.7.17.3 Programming example: Machining bar material
If you use bars to produce your workpieces, you can machine several workpieces on the
front and rear face by starting the program just once.
Programming steps - alternative 1:
Program header specifying the work offset in which the workpiece zero is stored
Machining, main spindle
Complete (withdraw blank: yes; cut-off cycle: yes)
Cutting-off
Machining, counterspindle
End of program with number of workpieces to be machined
Programming steps - alternative 2:
Start marker
Machining, main spindle
Complete (withdraw blank: yes; cutting-off cycle: yes)
Cutting-off
Machining, counterspindle
Front face
End marker
Repeat from start to end marker

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D Turning and is the answer not in the manual?

Siemens SINUMERIK 828D Turning Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 828D Turning
CategoryController
LanguageEnglish

Related product manuals