EasyManuals Logo

Siemens SINUMERIK 828D Turning User Manual

Siemens SINUMERIK 828D Turning
822 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #644 background imageLoading...
Page #644 background image
Managing programs
12.4 Creating a directory / program / job list / program list
Turning
644 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
If the selected program is already opened in the "Program" operating
area,
Press the "Execute NC" softkey.
Press the <CYCLE START> key.
Execution of the workpiece is started.
Note
Only workpieces/programs that are located in the NCK memory, local drive or USB drive can
be selected for execution.
12.4 Creating a directory / program / job list / program list
12.4.1 Creating a new directory
Directory structures help you to manage your program and data transparently. You can
create subdirectories in a directory on the local drive and on USB/network drives.
In a subdirectory, in turn, you can create programs and then create program blocks for them.
Note
Directory names must end in .DIR or .WPD. The maximum name length is 49 characters
including the extension.
All letters (except accented characters), numbers, and underscores are permitted for name
assignment. These names are automatically converted to upper-case letters.
This limitation does not apply for work on USB/network drives.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D Turning and is the answer not in the manual?

Siemens SINUMERIK 828D Turning Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 828D Turning
CategoryController
LanguageEnglish

Related product manuals