Setting up the machine
2.7 Zero offsets
Turning
90 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
4. Press the "Details" softkey.
5. Position the cursor on the zero offset you would like to delete.
6. Press the "Clear offset" softkey.
2.7.7 Measuring the workpiece zero
Procedure
1. Select the "Parameters" operating area and press the "Zero offset"
softkey.
2. Press the "G54...G599" softkey and select the zero offset in which the
zero point is to be saved.
3. Press the "Workpiece zero" softkey.
You change to the "Set Edge" window in the "JOG" mode.
4. Traverse the tool in the Z direction and scratch it.
5. Enter the position setpoint of the workpiece edge Z0 and press the "Set
ZO" softkey.
To Next Page
Loading...
