Siemens SINUMERIK 828D Turning - Preloading Milling Tools - Only for G Code Program (CYCLE800)

Programming technology functions (cycles)
8.6 Further cycles and functions
Turning
484 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
β Rotation around the 3rd geometry axis (for G18 Y) Degrees
Tool Tool tip when swiveling
• Correct
The position of the tool tip is maintained during swiveling.
• No correction
The position of the tool tip is not maintained during swiveling.
8.6.2.3 Preloading milling tools - only for G code program (CYCLE800)
After "Swivel plane", the tool orientation is always perpendicular on the machining plane.
When milling with radial cutters, it can make technological sense to set the tool at an angle
to the normal surface vector. In the swivel cycle, the setting angle is generated by an axis
rotation (max. +/- 90 degrees) to the active swivel plane. When setting, the swivel plane is
always “additive”. With "Setting tool", only rotations are displayed on the swivel cycle input
screen form. The user can freely select the rotation sequence.
Machine manufacturer
Please refer to the machine manufacturer's specifications.
7&3
7RROOHQJWK
5 7&3
5
Figure 8-6 The length up to the TCP (Tool Center Point) must be entered as tool length of the radial
cutter.