Multi-channel machining (only 840D sl)
9.2 Multi-channel support (only 840D sl)
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
543
9.2.5.2 Editing a G code multi-channel program
Editing a G code multi-channel program
Precondition
● The "programSYNC" option is set.
● In order to display the machining at the counterspindle at the correct position in the
simulation, the linear axis of the counterspindle must be positioned before CYCLE208
(multi-channel data).
Machine manufacturer
Please refer to the machine manufacturer's specifications.
Procedure
1. Position the cursor in the "Workpieces" folder on a job list and press the
"Open" softkey.
Note:
If the cursor is located on a workpiece, then a search is made for a job
list with the same name.
The "Job list ..." window opens and the program assignment to the
channels is displayed.
2. Press the "OK" softkey.
The programs are displayed next to one another in the editor.
3. Position the cursor on the first block of the program (multi-channel data)
and press the <Cursor right> key.
The parameter screen "Multi-channel data" is opened.
4. Enter the required values if you wish to change cross-channel data.
To Next Page
Loading...
Need help?
General
