EasyManuals Logo

Siemens SINUMERIK 828D Turning User Manual

Siemens SINUMERIK 828D Turning
822 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #141 background imageLoading...
Page #141 background image
Machining the workpiece
4.10 Editing a program
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
141
4.10.2 Replacing program text
You can find and replace text in one step.
Requirement
The desired program is opened in the editor.
Procedure
1. Press the "Search" softkey.
A new vertical softkey bar appears.
2. Press the "Find and replace" softkey.
The "Find and Replace" window appears.
3. In the "Text" field, enter the term you are looking for and in the "Replace
with" field, enter the text you would like to insert automatically during the
search.
4. Position the cursor in the "Direction" field and choose the search
direction (forward, backward) with the <SELECT> key.
5. Press the "OK" softkey to start the search.
If the text you are searching for is found, the corresponding line is
highlighted.
6. Press the "Replace" softkey to replace the text.
- OR -
Press the "Replace all" softkey to replace all text in the file that
corresponds to the search term.
- OR -
Press the "Continue search" softkey if the text located during the search
should not be replaced.
- OR -
Press the "Cancel" softkey when you want to cancel the search.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK 828D Turning and is the answer not in the manual?

Siemens SINUMERIK 828D Turning Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK 828D Turning
CategoryController
LanguageEnglish

Related product manuals