Managing programs
12.12 Set up drives
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
661
...
3. Press the ">>" and "Properties" softkeys.
The "Properties from ..." window appears.
4. Enter any necessary changes.
Note: You can save changes via the user interface in the NC memory.
5. Press the "OK" softkey to save the changes.
12.12 Set up drives
12.12.1 Overview
Up to eight connections to so-called logical drives (data carriers) can be configured. These
drives can be accessed in the "Program manager" and "Startup" operating areas.
The following logical drives can be set up:
● USB interface
● CompactFlash card of the NCU, only for SINUMERIK Operate in the NCU
● Network drives
● Local hard disk of the PCU, only for SINUMERIK Operate on the PCU
Software option
In order to use the CompactFlash card as data carrier, you require the "Additional
HMI user memory on CF card of the NCU" option (not for SINUMERIK Operate on
PCU or PC).
Note
The USB interfaces of the NCU are not available for SINUMERIK Operate and therefore
cannot be configured.
To Next Page
Loading...
