Siemens SINUMERIK 828D Turning - Selection of the Cycles Via Softkey

Creating a ShopTurn program
7.14 Selection of the cycles via softkey
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
247
7.14 Selection of the cycles via softkey
Overview of the machining steps
The following machining steps are available.
All of the cycles/functions available in the control are shown in this display. However, at a
specific system, only the steps possible corresponding to the selected technology can be
selected.
⇒ ⇒
⇒
⇒
⇒
⇒ ⇒