Machining the workpiece
4.12 Displaying G functions and auxiliary functions
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
161
References
● Additional information is available in the following references:
Function Manual, Basic Functions; Chapter, "Contour/orientation tolerance"
● For information about configuring the displayed G groups, refer to the following
document:
Commissioning Manual SINUMERIK Operate (IM9) / SINUMERIK 840D sl
Procedure
1. Select the "Machine" operating area
2.
Press the <JOG>, <MDI> or <AUTO> key.
3. Press the ">>" and "All G functions" softkeys.
The "G Functions" window is opened.
See also
High-speed settings (CYCLE832) (Page 486)
To Next Page
Loading...
