Simulating machining
5.1 Overview
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
179
Start position for simulation and simultaneous recording
During simulation, the start position is converted via the zero offset to the workpiece
coordinate system.
The simultaneous recording starts at the position at which the machine is currently located.
Constraint
● Referencing: G74 from a program run does not function.
● Alarm 15110 "REORG block not possible" is not displayed.
● Compile cycles are only partly supported.
● No PLC support.
● Axis containers are not supported.
● Swivel tables with non-swiveling offset vectors are not supported.
Supplementary conditions
● All of the existing data records (toolcarrier / TRAORI, TRANSMIT, TRACYL) are
evaluated and must be correctly commissioned for correct simulation.
● Transformations with swiveled linear axis (TRAORI 64 - 69) as well as OEM
transformations (TRAORI 4096 - 4098) are not supported.
● Changes to the toolcarrier or transformation data only become effective after Power On.
● Transformation change and swivel data record change are supported. However, a real
kinematic change is not supported, where a swivel head is physically changed.
● The simulation of mold making programs with extremely short block change times can
take longer than machining, as the computation time distribution for this application is
dimensioned in favor of the machining and to the detriment of simulation.
To Next Page
Loading...
Need help?
General
