Creating a ShopTurn program
7.8 Tool, offset value, feedrate and spindle speed (T, D, F, S, V)
Turning
240 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Converting the spindle speed (S) / cutting rate (V) when milling
As an alternative to the cutting rate, you can also program the spindle speed.
For the milling cycles, the cutting rate (m/min) that is entered is automatically converted into
the spindle speed (rpm) using the tool diameter - and vice versa.
Machining
When machining some cycles, you can choose between roughing, finishing, or complete
machining. For certain milling cycles, finishing edge or finishing base are possible.
● Roughing
One or more machining operations with depth infeed
● Finishing
Single machining operation
● Edge finishing
Only the edge of the object is finished
● Base finishing
Only the base of the object is finished
● Complete machining
Roughing and finishing with one tool in a
● machining step
If you want to rough and finish using two different tools, you must call the machining cycle
twice (1st block = roughing; 2nd block = finishing). The programmed parameters are
retained when the cycle is called for the second time.
To Next Page
Loading...
Need help?
General
