Programming technology functions (cycles)
8.1 Drilling
Turning
280 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
Position
(only for
ShopTurn)
• At the front (face)
• At the rear (face)
• Outside (peripheral surface)
• Inside (peripheral surface)
(only for
ShopTurn)
Clamp/release spindle
The function must be set up by the machine manufacturer.
Centering
• Diameter (centered with reference to the diameter)
The angle for the center drill entered in the tool list is applied.
• Tip (centered with reference to the depth)
The drill is inserted into the workpiece until the programmed insertion depth is reached.
∅ It is inserted into the workpiece until the diameter is correct. - (for diameter centering
only)
mm
Z1
Drilling depth (abs) or drilling depth in relation to Z0 (inc)
It is inserted into the workpiece until it reaches Z1. - (for tip centering only)
mm
DT
• Dwell time (at final drilling depth) in seconds
• Dwell time (at final drilling depth) in revolutions
s
rev
To Next Page
Loading...
