Siemens SINUMERIK 828D Turning - Page 31

Introduction
1.2 Operator panel fronts
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
31
/
<CTRL> + <L>
Scrolls the actual user interface through all installed languages one
after the other.

/
<CTRL> + <SHIFT> + <L>
Scrolls the actual user interface through all installed languages in
the inverse sequence.
3
<CTRL> + <P>
Generates a screenshot from the actual user interface and saves it
as file.
6
<CTRL> + <S>
Switches the single block in or out in the simulation.
9
<CTRL> + <V>
• Pastes text from the clipboard at the actual cursor position.
• Pastes text from the clipboard at the position of a selected text.
;
<CTRL> + <X>
Cuts out the selected text. The text is located in the clipboard.
<
<CTRL> + <Y>
Reactivates changes that were undone (only in the program editor).
=
<CTRL> + <Z>
Undoes the last action (only in the program editor).

&
<CTRL> + <ALT> + <C>
Creates a complete standard archive (.ARC) on an external data
carrier (USB-FlashDrive) (for 840D sl / 828D).
Note:
Please refer to the machine manufacturer's specifications.

6
<CTRL> + <ALT> + <S>
Creates a complete standard archive (.ARC) on an external data
carrier (USB-FlashDrive) (for 840D sl).
Creates a complete Easy Archive (.ARD) on an external data
carrier (USB-FlashDrive) (for 828D).
Note:
Please refer to the machine manufacturer's specifications.

'
<CTRL> + <ALT> + <D>
Backs up the log files on the USB-FlashDrive. If a USB-FlashDrive
is not inserted, then the files are backed-up in the manufacturer's
area of the CF card.