Programming technology functions (cycles)
8.2 Rotate
Turning
326 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameters Description Unit
P Thread pitch (select from the preset DIN table or enter) mm/rev
X0 Reference point X ∅ mm
Z0 Reference point Z mm
α Insertion angle Degrees
VX Cross feed ∅ (abs) or cross feed (inc) - (only for ∇∇∇ and ∇ + ∇∇∇) mm
D Maximum depth infeed – (only for ∇ and ∇ + ∇∇∇) mm
U or UX Finishing allowance in X or finishing allowance in X and Z – (only for ∇ and ∇ +
∇∇∇)
mm
UZ Finishing allowance in Z – (only for UX, ∇ and ∇ + ∇∇∇) mm
* Unit of feedrate as programmed before the cycle call
Parameters, G code program (undercut, thread) Parameters, ShopTurn program (undercut, thread)
PL Machining plane T Tool name
SC Safety clearance mm D Cutting edge number
F Feedrate * F Feedrate mm/rev
S / V
Spindle speed or constant
cutting rate
rpm
m/min
Parameters Description Unit
Machining
• ∇ (roughing)
• ∇∇∇ (finishing)
• ∇ + ∇∇∇ (roughing and finishing)
Machining
direction
• Longitudinal
• Parallel to the contour
Position
Machining position:
X0 Reference point X ∅ mm
Z0 Reference point Z mm
X1 Undercut depth referred to X ∅ (abs) or undercut depth referred to X (inc) mm
Z1 Allowance Z (abs or inc) mm
R1 Rounding radius 1 mm
R2 Rounding radius 2 mm
To Next Page
Loading...
