Programming technology functions (cycles)
8.4 Milling
Turning
408 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameter Description Unit
CP
X0 or L0
Y0 or C0
Z0
(only for
ShopTurn)
Face Y: The positions refer to the reference point:
Positioning angle for machining area – (only single position)
Reference point X or reference point length polar – (only for single position)
Reference point Y or reference point angle polar - (only for single position)
Reference point Z - (only for single position)
Degrees
mm
mm or
degrees
mm
Y0 or C0
Z0
X0
(only for
ShopTurn)
Peripheral surface C: The positions refer to the reference point:
Reference point Y or reference point angle polar - (only for single position)
Reference point Z - (only for single position)
Cylinder diameter ∅ – (only for single position)
mm or
degrees
mm
mm
C0
Y0
Z0
X0
(only for
ShopTurn)
Peripheral surface Y: The positions refer to the reference point:
Positioning angle for machining surface – (only for single position)
Reference point Y – (only for single position)
Reference point Z – (only for single position)
Reference point X – (only for single position)
Degrees
mm
mm
mm
W Slot width mm
L Slot length mm
α0 Angle of rotation of slot
Face: α0 refers to the X axis or to the position of C0 with a polar reference point
Peripheral surface: α0 refers to the Y axis
Degrees
Z1 Slot depth (abs) or depth relative to Z0 or X0 (inc) - (only for ∇ and ∇∇∇) mm
DXY
(only ShopTurn)
• Maximum plane infeed
• Maximum plane infeed as a percentage of the milling cutter diameter
- (only for ∇ and ∇∇∇)
mm
%
DZ Maximum depth infeed - (only for ∇, ∇∇∇ and ∇∇∇ edge) mm
UXY Plane finishing allowance for the length (L) and width (W) of the slot.
- (only for ∇ and ∇∇∇)
mm
UZ Depth finishing allowance (tool axis) - (only for ∇ and ∇∇∇) mm
To Next Page
Loading...
