Programming technology functions (cycles)
8.5 Contour milling
Turning
468 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
6. Steps 4 and 5 are repeated until the programmed spigot depth is reached.
7. The tool retracts to the safety clearance at rapid traverse.
Procedure
1. The part program or ShopTurn program to be processed has been
created and you are in the editor.
2. Press the "Milling", "Contour milling" and "Spigot" softkeys.
The "Mill spigot" input window opens.
3. Select the "Roughing" machining type.
Parameters, G code program Parameters, ShopTurn program
PRG Name of the program to be
generated
T Tool
name
PL
Machining plane D Cutting
edge
numbe
r
Milling direction
• Climbi
ng
• Conv
ention
al
millin
g
F
Feedra
te
mm/min
mm/tooth
RP Retraction plane mm S / V
Spindl
e
speed
or
consta
nt
cutting
rate
rpm
m/min
SC Safety clearance mm
F Feedrate mm/mi
n
To Next Page
Loading...
