Programming technology functions (cycles)
8.5 Contour milling
Turning
472 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
parameters Description Unit
TR Reference tool Tool, which is used in the "stock removal" machining step. This is used
to determine the residual corners.
D Cutting edge number
Z0 Reference point in tool axes Z mm
Z1
Pocket depth (abs) or depth referred to Z0 mm
CP Positioning angle for machining area
- (only for ShopTurn, machining surface, face Y)
Degrees
C0 Positioning angle for machining surface
- (only for ShopTurn, machining surface, peripheral surface Y)
Degrees
DXY
• Maximum plane infeed
• Maximum plane infeed as a percentage of the milling cutter diameter
mm
%
DZ Maximum depth infeed
Lift mode
Lift mode before new infeed
If the machining operation requires several points of insertion, the retraction height can
be programmed:
• To retraction plane
• Z0 + safety clearance
When making the transition to the next insertion point, the tool returns to this height. If
there are no elements larger than Z0 in the pocket area, Z0 + safety clearance" can be
selected as the lift mode.
mm
mm
FS Chamfer width for chamfering - (only for chamfering machining) mm
ZFS Insertion depth of tool tip (abs or inc) - (for chamfering machining only) mm
To Next Page
Loading...
