Siemens SINUMERIK 828D Turning - Page 512

Programming technology functions (cycles)
8.7 Additional cycles and functions in ShopTurn
Turning
512 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Parameters Description Unit
Y
Z
Machining plane peripheral surface/peripheral surface C
Pole Y (abs)
Pole Z (abs) or pole Z referred to the last programmed position (inc)
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
Y
Z
Machining plane, peripheral surface Y
Pole Y (abs)
Pole Z (abs) or pole Z referred to the last programmed position (inc)
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
X
Y
Machining plane face/face C
Pole X ∅ (abs)
Pole Y (abs) or pole Y referred to the last programmed position (inc)
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
X
Y
Machining plane face Y
Pole X (abs)
Pole Y (abs) or pole Y referred to the last programmed position (inc)
Note:
Incremental dimension: The sign is also evaluated.
mm
mm
X
Z
Machining plane rotation
Pole X (abs) or pole X referred to the last programmed position (inc)
Z position pole (abs)
Note:
Incremental dimension: The sign is also evaluated.
mm
mm