Programming technology functions (cycles)
8.7 Additional cycles and functions in ShopTurn
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
525
Parameter Description Unit
Function, rear face
Work offset Work offset in which the coordinate system, which was shifted according to ZW
and by ZV as well as mirrored in Z, must be saved:
• Basic reference
• G54
• G55
• G56
• G57
• ...
Write to the work offset
• Yes
The Z value of the work offset can be directly written to the input screen form.
• No
The actual Z value of the work offset is used.
ZV (abs) - only for work
offset. write "yes"
Z value of the work offset.
mm
ZV (inc) Workpiece zero is offset in Z direction (the sign is also evaluated) mm
See also
Program header (Page 234)
Program header with multi-channel data (Page 546)
To Next Page
Loading...
