Tool management
11.11 Specific search in the tool management lists
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
619
Procedure
1. Select the "Parameter" operating area.
...
2. Press the "Tool list", "Tool wear" or "Magazine" softkey.
3. Press the ">>" and "Search" softkeys.
4. Press the "Tool" softkey if you wish to search for a specific tool.
- OR -
Press the "Magazine location" softkey if you wish to search for a
specific magazine location or a specific magazine.
- OR -
Press the "Empty location" softkey if you wish to search for a specific
empty location.
5. Press the "OK" softkey.
The search is started.
6. Press the "Search" softkey again if the tool that was found is not the
tool that was being searched for.
The search term is kept and with "OK" you start the search for the next
tool that corresponds to the entry.
7. Press the "Cancel" softkey to cancel the search.
To Next Page
Loading...
Need help?
General
