Ladder Viewer and Ladder add-on (828D only)
23.12 Inserting and editing networks
Turning
798 Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
Procedure
1. An INT100 or INT101 routine has been selected.
2. Press the "Edit" softkey.
3. Position the cursor on a network.
4. Press the "Insert network" softkey.
- OR -
Press the <INSERT> key.
If the cursor is positioned on "Network x", a new, empty network is
inserted behind this network.
5. Position the cursor on the desired element below the network title and
press the "Insert operation" softkey.
The "Insert Operation" window appears.
6. Select the desired bit operation (NC contact or NO contact) or
assignment and press the "OK" softkey.
7. Press the "Insert operand" softkey.
8. Enter the logic operation or the command and press the <INPUT> key
to complete the entry.
9. Position the cursor on the operation that you want to delete and press
the "Delete operation" softkey.
- OR -
Position the cursor on the title of the network that you want to delete
and press the "Delete network" softkey.
- OR -
Press the <DEL> key.
The network, including all the logic operations and operands, or the
selected operation is deleted.
To Next Page
Loading...
