Ladder Viewer and Ladder add-on (828D only)
23.20 Displaying cross references
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
807
5. Select the desired cross reference and press the "Open in window 1" or
"Open in window 2" softkey.
The ladder diagram is opened, and the selected operand is marked.
6. Press the "Find" softkey.
The "Find / Go To" window appears.
7. Select "Find operand" or "Go to" and enter the sought element or the
desired line and select the search order (e.g. search up).
8. Press the "OK" softkey to start the search.
9. If an an element is found that corresponds to the sought element, but is
not at the appropriate position, press the "Continue search" softkey to
find where the search term occurs next.
To Next Page
Loading...
