Setting up the machine
2.7 Zero offsets
Turning
Operating Manual, 03/2013, 6FC5398-8CP40-3BA1
85
Zero offsets
G500 Displays the zero offsets activated with G54 - G599.
Under certain circumstances, you can change the data using "Set ZO",
i.e. you can correct a zero point that has been set.
Tool reference Displays the additional zero offsets programmed with
$P_TOOLFRAME.
Workpiece reference Displays the additional zero offsets programmed with $P_WPFRAME.
Programmed ZO Displays the additional zero offsets programmed with $P_PFRAME.
Cycle reference Displays the additional zero offsets programmed with $P_CYCFRAME.
Total ZO Displays the active zero offset, resulting from the total of all zero
offsets.
Procedure
1. Select the "Parameter" operating area.
2 Press the "Zero offset" and "Overview" softkeys.
The "Zero Offsets - Overview" window opens.
To Next Page
Loading...
