Siemens SINUMERIK 828D - Page 29

Introduction
2.2 Operator panel fronts
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
29
<PAGE DOWN>
Scrolls downwards by one page in a window.
<PAGE DOWN> + <SHIFT>
In the program manager and in the
program editor, from the
cursor position, selects directories or program blocks up to the
end of the window.
<PAGE DOWN> + <CTRL>
Positions the cursor to the lowest line of a window.
<Cursor right>
•
Editing box
Opens a directory or program (e.g. cycle) in the editor.
•
Navigation
Moves the cursor further to the right by one character.
<Cursor right> + <CTRL>
•
Editing box
Moves the cursor further to the right by one word.
•
Navigation
Moves the cursor in a table to the next cell to the right.
<Cursor left>
•
Editing box
Closes a directory or program (e.g. cycle) in the program
editor. If you have made changes, then these are accepted.
•
Navigation
Moves the cursor further to the left by one character.
<Cursor left> + <CTRL>
•
Editing box
Moves the cursor further to the left by one word.
•
Navigation
Moves the cursor in a table to the next cell to the left.