Siemens SINUMERIK 828D - Page 315

Programming technology functions (cycles)
9.1 Drilling
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
315
Retraction
Retraction can be realized at the pilot hole depth or the retraction plane.
● Retraction to the retraction plane is realized with G0 or feedrate, programmable speed as
well as direction of rotation respectively stationary spindle.
● For retraction at the pilot hole depth, subsequent retraction and insertion are realized with
the same data.
Note
Direction of spindle rotation
The direction of spindle rotation is not reversed; however, where necessary, can be
stopped.
Coolant
The technology and tools require that also in the G code, the control for the coolant is
supported.
● Coolant on
Switch on at Z0 + safety clearance or at the pilot hole depth (if a pilot hole is being used)
● Coolant off
Always switch off at the final drilling depth
● Programming in the G code
An executable block (M command or subprogram call), which can be programmed as
string.
Procedure
1.
The part program or ShopTurn program to be processed has been cr
e-
ated and you are in the editor.
2.
Press the "Drilling" softkey.
3.
Press the "Deep
-hole drilling" and "Deep-hole drilling 2" softkeys.
The "Deep
-hole drilling 2" input window opens.