Siemens SINUMERIK 828D - Page 326

Programming technology functions (cycles)
9.1 Drilling
Turning
326 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Parameter
Description
Unit
Position
(only for Shop-
Turn)
• At the front (face)
• At the rear (face)
• Outside (peripheral surface)
• Inside (peripheral surface)
(only for Shop-
Turn)
Clamp/release spindle
The function must be set up by the machine manufacturer.
Z1 End point of the thread (abs) or thread length (inc) - only for G code and ShopTurn
machining surface "face")
It is inserted into the workpiece until it reaches Z1.
mm
X1 End point of the thread (abs) or thread length (inc) - (only for ShopTurn machining
surface, "peripheral")
It is inserted into the workpiece until X1 is reached.
mm
Pitch - (only ma-
chining without
encoder)
(only for G code)
• User input
Pitch is obtained from the input
• Active feedrate
Pitch is obtained from the feedrate
Thread
(only for G code)
Direction of rotation of the thread
• Right-hand thread
• Left-hand thread
(only in mode "without compensating chuck")
Table
Thread table selection:
• without
• ISO metric
• Whitworth BSW
• Whitworth BSP
• UNC
Selection
Selection of table value: e.g.
• M3; M10; etc. (ISO metric)
• W3/4"; etc. (Whitworth BSW)
• G3/4"; etc. (Whitworth BSP)
• 1" - 8 UNC; etc. (UNC)