Siemens SINUMERIK 828D - Page 328

Programming technology functions (cycles)
9.1 Drilling
Turning
328 Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
Parameter
Description
Unit
SDE
(only for G code)
Direction of rotation after end of cycle:
•
•
•
Technology Adapting the technology:
• Yes
– Exact stop
– Precontrol
– Acceleration
– Spindle
• No
Note:
The technology fields are only displayed if their display has been enabled.
Please observe the information provided by your machine manufacturer.
Exact stop (only
for technology,
yes)
• Empty: Behavior the same as it was before the cycle was called
• G601: Block advance for exact stop fine
• G602: Block advance for exact stop coarse
• G603: Block advance if the setpoint is reached
Precontrol (only
for technology,
yes)
• Empty: Behavior the same as it was before the cycle was called
• FFWON: with precontrol
• FFWOF: without precontrol
Acceleration (only
for technology,
yes)
(only in mode "without compensating chuck")
• Empty: Behavior the same as it was before the cycle was called
• SOFT: Jerk-limited (soft) acceleration of the axes
• BRISK: Abrupt acceleration of the axes
• DRIVE: Reduced axis acceleration
Spindle (only for
technology, yes)
(only in mode "without compensating chuck")
• Speed controlled: Spindle for MCALL: Speed-controlled mode
• Position controlled: Spindle for MCALL: Position-controlled operation