Siemens SINUMERIK 828D - Page 329

Programming technology functions (cycles)
9.1 Drilling
Turning
Operating Manual, 01/2015, 6FC5398-8CP40-5BA2
329
Parameters in the mode "Input simple" (only for G code program)
G code program parameters
Input
• simple
RP Retraction plane mm
Parameter
Description
Compensating
chuck mode
• with compensating chuck
• Without compensating chuck
Machining
position
• Single position
Drill hole at programmed position.
• Position pattern
Position with MCALL
Z0
Reference point Z
mm
Z1 End point of the thread (abs) or thread length (inc)
It is inserted into the workpiece until it reaches Z1.
mm
Machining - (with
compensating
chuck)
• With encoder
Tapping with spindle encoder
• without encoder
Tapping without spindle encoder; selection:
- Define "Pitch" parameter
Pitch - (only ma-
chining without
encoder)
• User input
Pitch is obtained from the input
• Active feedrate
Pitch is obtained from the feedrate
Thread Direction of rotation of the thread
• Right-hand thread
• Left-hand thread
(only in mode "without compensating chuck")
P Pitch ...
• in MODULUS: MODULUS = Pitch/π
• in turns per inch: Used with pipe threads, for example.
When entered per inch, enter the integer number in front of the decimal point in the
first parameter field and the figures after the decimal point as a fraction in the sec-
ond and third field.
• in mm/rev
• in inch/rev
The pitch is determined by the tool being used
MODULUS
Turns/"
mm/rev
in/rev
S
Spindle speed - (only for tapping without compensating chuck)